This product is controlled by a single live wire switch, and the main isolation switch needs to be disconnected during maintenance to avoid electric shock. After installation, the black antenna on the switch needs to be straightened to avoid affecting the remote control distance. When the remote control distance drops, please check the battery power of the remote control, and replace it in time when the battery power is insufficient.
Product Parameters
| Product name |
Remote Control Switch |
| Voltage |
220V |
| Encoding mode |
Learning to code |
| Load type |
Motor,water pump,energy-saving lamp |
| Remote control distance |
500m/1000m/3000m |
Installation and operation instructions
1.Please install correctly according to the installation wiring diagram.The 220V switch is suitable for the equipment with power below 3.5kw and can be used directly.The 380V switch must be used with the AC contactor.
2.Code matching:press and hold the ON/OFF key for 2 seconds,and the power indicator flashes.At this time,press the ON or OFF key of the remote control,and the power indicator stops flashing,indicating that the code matching is successful.
3.Code clearing:press and hold the ON/OFF key for 5 seconds,and the power indicator flashes at intervals,indicating that the code clearing is successful.
4.The installation height of the switch shall be more than 1.5m higher than the ground.The black receiving antenna of the host needs to be straightened and erected.It is strictly prohibited to cut or extend the antenna outside.The switch shall not be installed in low-lying and humid environment.
5.Before use,please check whether the battery positive and negative poles of there mote control handle are placed correctly.Wrap the handle of the remote control with plastic film to avoid dust,mud and water entering the remote control key,resulting in poor contact or damage of the key.
6.The actual distance of remote control is generally between 30%and 80%of the nominal distance.The higher the switch is installed from the ground,the less the intermediate spacing,the farther the remote control distance is,and vice versa. Do not install the switch in the closed metal box,the metal can shield the wireless signal.
7.Once the product is sold,it is not a quality problem of its own.It can be replaced within 7 days and guaranteed within 6 months. If the product is burnt due to human damage,dampness and water,improper use,overload use,short circuit,etc.,the company will not guarantee replacement and warranty.
Packaging
Showroom
Workshop
Audited Supplier 
){kind=link}